Mounting Board for a Walker

A cutting board made of hard plastic with rubber trim (purchased at Lowes Hardware).
2 pipe holders (1/2 inch but this size would depend on the size of the bar on the walker). We removed the seat that came with the walker to put the board on and actually could have just used the holders on it.
1 piece 23-1/2" x 1/2" x 1/16" band iron (for support bar...not sure you can see it from the pictures).
6 small bolts (The ones he used were 1 1/2 in long but it would depend on the cutting board you are using.)
6 nuts
6 washers
Industrial strength velcro (purchased at Wal-Mart in the craft dept.)

He attached the support bar to the walker.
He attached the board to the support bar on the walker using the bolts, nuts and washers.
He then used velcro to attach the Vantage to the board.

Contact David with any questions on how he did this. jacksonlats@aol.com